Tuesday, November 5, 2019

Rotta Model for Bicycle Tires

I recently discovered Andrew Dressel who recently wrote a PhD dissertation Measuring and Modeling the Mechanical Properties of Bicycle Tires. There's a lot in there, of course, but amongst all that I found a description of the Rotta model for tires. This is much the same as what I have been exploring. I polished up my math and wrote a bit of new software to generate some new tables for recommended inflation pressures base on Frank Berto's rule of 15% squish.

The Rotta model is quite simple:

The tire is flat where it contacts the ground, and has a circular cross section where it is not in contact. Each cross section of the tire is treated independently.

Here are tables from which inflation pressure can be computed. The rows correspond to tire widths, in mm. The columns represent rim width, as a ratio to tire width. E.g. the column with 2 at the top is for tire width twice the inner rim width, e.g. a 50 mm wide tire on a 25 mm wide rim.

The tables give the area in square inches of the contact patch. To compute the inflation pressure, divide the load on the wheel by the area of the contact patch. E.g. a 50 mm tire on a 25-559 ETRTO rim will have a 2.06 sq in contact patch when it is squished down 15% of its width. For that contact patch to support a 100 pound load, the inflation pressure should be 100 / 2.06 = 48.5 PSI.

For 622 BSD:

For 559 BSD:

For 406 BSD:

These tables are calculated purely from theory, i.e. no parameters are used to fit them to any experimental data. Do not follow them blindly! They're food for thought & perhaps provide a useful starting point for exploration.

And a 305 BSD table:

2 comments:

  1. do check out: https://www.youtube.com/watch?v=asEYkpW0vwQ

    ReplyDelete
  2. GCN is in the room: https://www.youtube.com/watch?v=6rMnNI2RCgw

    ReplyDelete